Mitsubishi Lancer Owners Manual
Rear combination lampsMaintenance / Replacement of lamp bulbs / Rear combination lamps
Stop and tail lamps and rear turn-signal lamps
1. Insert a straight blade (or minus) screwdriver with the end covered with a cloth or other object at the edge of the cover and pry gently to remove the cover.
2. Remove the socket and bulb assemblies by turning them anticlockwise.
A- Rear turn-signal lamp
B- Stop and tail lamp
3. Remove the bulb by pulling it out.
4. To install the bulb, perform the removal steps in reverse.
Note
► When installing the cover, make sure the arrow on the cover is pointing in the direction of the front of the vehicle.
: Front of the vehicle
Reversing lamps
1. Insert a straight blade (or minus) screwdriver with the end covered with a cloth or other object into the cut out area of the cover and pry gently to remove the cover.
2. Remove the socket and bulb assembly by turning it anticlockwise.
3. Remove the bulb by pulling it out.
4. To install the bulb, perform the removal steps in reverse.
Note
► When installing the lid, align the tab on the lid with the hole on the vehicle side.
