Mitsubishi Lancer Owners Manual

Bending lamps (Adaptive Front lighting System (AFS)) (for vehicles equipped with high intensity discharge headlamps)
Maintenance / Replacement of lamp bulbs / Bending lamps (Adaptive Front lighting System (AFS)) (for vehicles equipped with high intensity discharge headlamps)

1. When replacing the bulb on the right side of the vehicle, remove the bolt (A) holding down the washer tank spout and move the spout towards the rear of the vehicle.

Mitsubishi Lancer: Bending lamps (Adaptive Front lighting System (AFS)) (for vehicles equipped
with high intensity discharge headlamps). : Front of the vehicle

: Front of the vehicle

2. Turn the cap (B) anticlockwise to remove it.

Mitsubishi Lancer: Bending lamps (Adaptive Front lighting System (AFS)) (for vehicles equipped
with high intensity discharge headlamps). : Front of the vehicle

: Front of the vehicle

3. Turn the bulb (C) anticlockwise to remove it.

Mitsubishi Lancer: Bending lamps (Adaptive Front lighting System (AFS)) (for vehicles equipped
with high intensity discharge headlamps). : Front of the vehicle

: Front of the vehicle

4. While pressing the tab (D), pull out the bulb (E).

Mitsubishi Lancer: Bending lamps (Adaptive Front lighting System (AFS)) (for vehicles equipped
with high intensity discharge headlamps). 5. To install the bulb, perform the removal steps in reverse.

5. To install the bulb, perform the removal steps in reverse.

Mitsubishi Lancer: Bending lamps (Adaptive Front lighting System (AFS)) (for vehicles equipped
with high intensity discharge headlamps). Caution Caution

► Handle halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is highly pressurized, so dropping, knocking, or scratching a halogen lamp bulb can cause it to shatter.
► Never hold the halogen lamp bulb with a bare hand, dirty glove, etc. The oil from your hand could cause the bulb to break the next time the bending lamps (Adaptive Front lighting System (AFS)) are operated.

If the glass surface is dirty, it must be cleaned with alcohol, paint thinner, etc., and refit it after drying it thoroughly.

Mitsubishi Lancer: Bending lamps (Adaptive Front lighting System (AFS)) (for vehicles equipped
with high intensity discharge headlamps). Position lamps (except for vehicles equipped with high intensity discharge headlamps)


© 2024 www.mitsuguide.com. All Rights Reserved.